135
8024A–AVR–04/08
ATmega8HVA/16HVA
24. FET Control
24.1
Overview
The FET control is used to enable and disable the Charge FET and Discharge FET. Normally,
the FETs are enabled and disabled by SW writing to the FET Control and Status Register
(FCSR). However, the autonomous Battery Protection circuitry will if necessary override SW set-
tings to protect the battery cells from too high Charge- or Discharge currents. Note that the CPU
is never allowed to enable a FET that is disabled by the battery protection circuitry. The FET
control is shown in Figure 24-1.
If Current Protection is activated by the Battery Protection circuitry both the Charge-FET and
Discharge FET will be disabled by hardware. When the protection disappears the Current Pro-
tection Timer will ensure a hold-off time of 1 second before software can re-enable the external
FETs.
If C-FET is disabled and D-FET enabled, discharge current will run through the body-drain diode
of the C-FET and vice versa. To avoid the potential heat problem from this situation, software
must ensure that D-FET is not disabled when a charge current is flowing, and that C-FET is not
disabled when a discharge current is flowing.
If charging deeply over-discharged cells, the FET driver must be operated in the Deep Under-
voltage Recovery mode. When the cell voltage raises to an acceptable level, Deep Under-volt-
age Recovery mode should be disabled by software by setting the FCSR (DUVRD bit). To avoid
that C-FET is opened while current protection is active, DUVR mode is automatically disabled by
hardware, in this case.
Figure 24-1. FET Control Block Diagram
24.1.1
FETs disabled during reset
During reset, both FETs will be disabled immediately and the chip will exit from DUVR mode. It is
important to notice that a reset will lead to an immediate disabling of the FETs regardless of the
Battery Protection parameter settings. A BOD reset may occur as a result of a short-circuit con-
dition. Depending on the selected Battery Protection Timing, actual current consumption and
dimensioning of CREG, a BOD reset may occur before the Battery Protection delay timing has
expired, causing the FETs to be disabled.
FET
Control
and
Status
Register
DFE
CFE
BATTERY_PROTECTION
Power-off Mode
8-
B
IT
D
A
T
A
B
U
S
CHARGE_EN
DISCHARGE_EN
DUVRD
DUVR_OFF
Current Protection
Timer
相关PDF资料
ATSAM3N4AA-AU MCU FLASH 48-QFP
ATSAM3SD8CA-CU IC MCU 2X256KB CORTEX-M3 100-QFN
ATSAM3U1EB-CU IC MCU 64KB CORTEX-M3 144-TFBGA
ATSAM3X8EA-CU IC MCU 2X256KB CORTEX-M3 144-BGA
ATTINY12V-1SUR IC AVR MCU 1K FLASH 4MHZ 8-SOIC
ATTINY13-20SQR IC MCU AVR 1KB FLASH 20MHZ 8SOIC
ATTINY13A-MMUR MCU AVR 1KB FLASH 20MHZ 10DFN
ATTINY13V-10SUR MCU AVR 1KB FLASH 10MHZ 8SOIC
相关代理商/技术参数
ATMEGA8HVA-4CKUR 功能描述:8位微控制器 -MCU AVR 8KB FLSH 512B EE 1KB SRAM - 4 MHZ RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA8HVA-4TU 功能描述:8位微控制器 -MCU AVR 8KB, 512B EE 4MHz 1KB SRAM 1.8-9V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA8HVA-4TUR 功能描述:8位微控制器 -MCU AVR 8KB FLSH 512B EE 1KB SRAM - 4 MHZ RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA8HVD-4MX 功能描述:8位微控制器 -MCU AVR 8KB, 512B EE 4MHz 1KB SRAM 2.1-8V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA8L-8AC 功能描述:8位微控制器 -MCU AVR 8K FLASH 512B EE 1K SRAM ADC 3V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA8L8AI 制造商:Atmel Corporation 功能描述:
ATMEGA8L-8AI 功能描述:8位微控制器 -MCU AVR 8K FLASH 512B EE 1K SRAM ADC 3V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA8L-8AJ 功能描述:IC MCU AVR 8K 5V 8MHZ 32-TQFP RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微控制器, 系列:AVR® ATmega 标准包装:9 系列:87C 核心处理器:8051 芯体尺寸:8-位 速度:40/20MHz 连通性:UART/USART 外围设备:POR,WDT 输入/输出数:32 程序存储器容量:32KB(32K x 8) 程序存储器类型:OTP EEPROM 大小:- RAM 容量:256 x 8 电压 - 电源 (Vcc/Vdd):4.5 V ~ 5.5 V 数据转换器:- 振荡器型:内部 工作温度:0°C ~ 70°C 封装/外壳:40-DIP(0.600",15.24mm) 包装:管件